Omron PLC PID Control (CX-Programmer)
- Knowledge about CX-Programmer
In this training course, you will learn the Omron Instruction for PID control, the PIDAT Instruction, and how to use it as well as adjust its parameters for different situations.
You will also learn the TPO instruction and learn how to convert PID analog output to digital by combining PID and TPO.
also in this training course, you will get acquainted with the parameters P, I, and D and you will see how each of them affects your control system.
Finally, in a practical project that is a thermoforming machine, we use the PID and TPO instructions and show how the PID instructions can be obtained automatically with the Auto-Tune capability of the PID instruction.
This course is based on my practical experiences and all the issues that have been used one by one in projects. so you can make sure you can use it without any problem in projects that you have.
Also, after viewing the course, if you think it is a useful topic that can be added to the course, send it to me so that it can be added to the course after review.
After watching this course, you can send your questions through the available communication channels and I will try to answer your questions.
Who this course is for:
- For everyone that uses or wants to use Omron PLC
Industrial Automation Engineer
Omron and Siemens
PLC and Motion control systems
Vision System Specialist
Some Of my Projects
Blister Vision Control
Car Assembly Line
Refine of industrial waste water by reverse
800T Press System
4 Line Filler Machine
Gearbox Dimensional Test
Sanitary Papers Machine
Control system of airplane hydraulic gauge
Control system of packing line
Control system of drink packing line