
After this lecture, the student will understand what they will be doing in this course in the way of programming and wiring a Micro 800 PLC. In following courses, the students will be able to incorporate the programs designed here into Human Machine Interface (HMI) format in order to monitor and run the programs from the HMI. In the third course, the students will be able to apply this knowledge to analog programming incorporating the Vafiable Frequency Drive.
After three courses, the students will be able to program and wire a Micro 800 Programmable Logical Controller (PLC), connect to and program a Panelview 800 Human Machine Interface (HM)I, and program and wire a variable frequency drive (VFD) and connect all three to perform a manufacturing application. This first course focuses primarely on programming and wiring the Micro 850 PLC.
The student will become familiar with the HMI as a preview to the second course of this three-part series.
This course encapsulates wiring and programming of the Micro 850 PLC with an emphasis on digital inputs and outputs, timers, counters, comparison, and math instructions. The Micro 850 is a recent product and is primarily used in small manufacturing processes and control. It is compatible with most Allen Bradley Human Machine Interfaces and Variable Frequency Drives. The first section is a general introduction to PLCs and where they are used and their purposes. The second section focuses on the nomenclature and physical properties of a PLC. The third section shows us how to wire inputs and outputs of a PLC, and speak a little towards sinking and sourcing inputs and outputs. In the next section, we program a short switch controlling an output. We program a start stop station and actually give an example of setting it up on the human machine interface device for monitoring and control. We introduce the electrical interlock program for forward and reverse motor control. We'll then program timers, counters, comparison instructions, and math instructions. The lessons are primarily provided by videos that contain lectures and physical demonstrations. It is advisable that the students have a little background in electrical circuitry. A little background in PLCs would be helpful but not absolutely necessary. Terms will be introduced like inputs, outputs, downloading and uploading, IP addresses, protocol, binary numbering systems, and addressing at the instruction level.