What you'll learn

Course content

1 section • 10 lectures • 1h 16m total length

Introduction2:15
Lesson 1 - How to import Machine Defination , Raw Stock and Material Settings7:49
PLEASE DOWNLOAD ATTACHED ZIP FILE FOR PRACTICE. THANKS.
Lesson 2 - How to use Levels and Create Dynamic Planes on part3:20
Lesson 3 - How to use Zigzag Facing Operation4:47
Lesson 4 - How to use and master the Dynamic Roughing & Finishing Toolpath.22:17
Lesson 5 - How to program machine to Finish FLOORS of part using Pocket Toolpath6:24
Lesson 6 - How to program machine to Finish WALLS of part using Contour Toolpath10:15
Lesson 7 - How to use Dynamic Peel Mill Toolpath in Special Feature of part3:10
Lesson 8 - How to machine part using Tip Compensation, Spot Drilling and Peck Dr9:23
Lesson 9 How to Simulate Part Maching in Real life using Backplot and Verify Fun6:40

In this course, you will learn programming Real life parts in Mastercam. All below Topics are covered:

- How to import Machine Defination , Raw Stock and Material Settings

- How to use Levels and Create Dynamic Planes on part

- How to use Zigzag Facing Operation

- How to use and master the Dynamic Roughing & Finishing Toolpath

- How to program machine to Finish FLOORS of part using Pocket Toolpath

- How to program machine to Finish WALLS of part using Contour Toolpath

- How to use Dynamic Peel Mill Toolpath in Special Feature of part

- How to machine part using Tip Compensation, Spot Drilling and Peck Drilling

- How to Simulate Part Maching in Real life using Backplot and Verify Functions