Revit MEP Masterclass- 3D Mechanical Room & Family Creation

Place dab pump families in a revit mep model, set 40 cm elevations, space pumps 40 cm apart with 50 cm to lines, verify sections using k 37 m boosters.

load and place softeners, salt tank, soft water tank, water tanks (100l, 301,000l), expansion tanks (100, 1000, 300l), foundations and clearances. Then proceed to piping.

Demonstrates piping a Revit mep pump setup with six inch suction and discharge pipes for chiller supply and return, gate valves, strainers, shock absorbers, and check valves, copied across pumps.

Draw and place inline pump piping in revit mep using two-inch galvanized supply and return pipes, dwr, and accessories like valves, strainer, and check valves, in section and 3d views.

Draw 16-inch galvanized steel collectors for the pumps, cap ends, and align with the collector axis; convert junctions to taps and connect pipes, then review the 3d model.

Draw soft water supply and return pipes from the salt tank to the collector in section and plan views using galvanized piping. Rotate the salt tank, set the pipe diameter to one inch, and align the pipes.

Revit MEP 3D mechanical room workshop guides you to model soft water piping, drawing six-inch galvanized supply and return collectors, raising elevations, aligning and trimming pipes, and placing valves.

Learn to design and route eight-inch supply and return pipes from collectors to the chiller and mechanical room, add valves, orifice plates, and expansion tanks, and manage elevations in 3D.

Edit and align collector pipes for vertical pumps, trim to connect, and check in 3d view for interferences while adjusting flange, valve placements, and elevations.