If you have a MikroTik router at home or at work which you don't know how to configure it to become a Wireless Access Point Router, this course can help you to achieve this.
During this course, I am going to show you step-by-step how to configure your MikroTik router to become a wireless Access Point. We will pass through many different topics such as: DHCP client configuration, DHCP server configuration, IP address assignment on interfaces, NAT configuration and much more.
This course will help you to feel more familiar with the MikroTik router by using the Winbox tool that I am going to use it during this course.
If you have any question during the course, you can always write me and I will answer your question ASAP.
In this lecture, the Eth1 interface on the MikroTik router will be connected to the cable provided from the ISP, and we will configure DHCP client on Eth1 interface to receive an IP address, subnet mask, DNS addresses and Defalut gateway from the ISP.
We will do a test to check if the configuration of the DHCP is done correctly.
In this lecture, we are going to configure the wireless part on the MikroTik router. This will include:
In this lecture and after the wireless has been enabled in the previous lecture, we are going to configure the MikroTik router to become a DHCP server in order to be able to provide private IP addresses to network devices that are connected to the wireless that we have just configure it.
After configuring the DHCP server, the devices that are connected wirelessly to the router are now getting a private IP address. For this reason, it is needed to have a NAT process on the router enabled to allow the private IP address to be translated to public IP addresses in order to go to the internet.
In this lecture, I will show you the steps needed to configure NAT on the MikroTik router.
In the previous lecture, we have finished the whole configuration on the MikroTik router to become a Wireless Access Point router and share the internet service wirelessly to other devices.
In this lecture, we are going to check if we can be connected to the internet in case my computer is connected to the wireless on the MikroTik router that we have created. This will justify also whether our whole configuration was done correctly.
Hello everyone. My name is Maher Haddad with a very long experience in the IT sector. I hold a Bachelor in Computer Communications and a Master in Computer science.
I work as a trainer and I hold the following certificates: CCNA, CCNA Security, CCNA Voice, CCDA, CCNP R&S, CCDP, Microsoft MCP, Microsoft MCSA , MikroTik MTCNA & MTCRE, MTCWE, MTCUME, CWTS, GVF Level1, GVF level2, GVF Level3 and much more.....
My experience in IT goes to year 2003 and I have been working all my life for international Internet Service Providers (ISP's) in different countries in the world.
You can visit my Facebook page as well as my Youtube channel where I set a lot of online labs.
I hope you will enjoy watching my courses.